Need help ordering online? Click here
FREE DELIVERY ON ORDERS OVER R 800
SAME DAY SHIPPING IN SOUTH AFRICA
blog
haircity.co.za

JANET ENCORE 100% HUMAN HAIR PREMIUM BLEND FULL LACE WIG SCANDAL

JANET ENCORE 100% HUMAN HAIR PREMIUM BLEND FULL LACE WIG SCANDAL

Sold out.

PRODUCT DETAIL

Product Name:  JANET COLLECTION 100% HUMAN HAIR PREMIUM FULL LACE WIG
Product Category:            JANET COLLECTION FULL LACE WIG
Brand:         JANET COLLECTION
Material: 100% HUMAN HAIR PREMIUM BLEND
Length: LONG
Style NATURAL BODY CURL

 

  1. HOW TO APPLY YOUR LACE WIG
  2. HOW TO BRUSH YOUR LACE WIG
  3. HOW TO CURL AND BLOW DRY
  4. HOW TO MAINTAIN YOUR LACE WIG
  5. HOW TO WASH YOUR LACE WIG
  6. HOW TO REMOVE YOUR LACE WIG

1. HOW TO APPLY YOUR LACE WIG

You will need: Steps:
  • Create a Flat Surface for the wig to sit on by either braiding your hair in small cornrows or wearing a wig cap to create a bump free and flat surface.
  • Cleanse your forehead with toner/water using a cotton ball. This will create a clean, oil free surface.
  • Cut the excess lace off the wig by using sharp scissors to trim the excess lace. Be careful not to cut any baby hairs.
  • Cut small amounts at a time and put your lace wig on a few times until you are satisfied that you have cut enough lace. The lace must look like a natural hairline.
  • Use the adjustable straps at the back of the wig to adjust the wig to your head size.
  • Once you are happy with the fit of the wig secure the wig with the combs and pin it into your hair
For extra hold:
    Sew in
  • Sew in a few tracks of the wig into your hair using a needle and thread. Sew in the first few tracks into your cornrows as you would do a normal weave.
  • Glue/ Tape:
  • Mark or gently outline where you want the wig to fit so that you do not apply adhesive outside of this area.
  • Apply adhesive to your hairline. Do this by either using glue or tape. If you are using lace glue let it dry for +- 15 minutes).
  • Apply your Lace Wig. Starting at the middle point of your forehead, bond the wig to your head by pressing down on one side, then the other, using the back end of a comb. Bond the front hairline first for lace front wigs then the nape for full lace wigs. If you have glue showing beyond the edges of the lace remove the excess glue using BMB Lace Glue Remover.
  • Let the glue dry completely before styling!

2. HOW TO BRUSH YOUR LACE WIG

You will need:
  • Paddle brush
Steps:
  • Allow hair to dry before you brush it in order to avoid damage to the fibre.
  • Use a comb and separate your hair into three sections.
  • Using your paddle brush start from the bottom and work your way up. This will remove tangles and knots.
  • Once all the knots have been removed, brush your hair from the top down in gentle strokes.
  • Remember the more you brush and wash your hair the more you damage the fibres of the hair.

3. HOW TO BLOW DRY AND CURL YOUR LACE WIG

You will need:
  • Curling iron or hair straightener
  • Hair dryer
    Curling
  • Once you remove the curler, do not pull the hair, just slide the curler out of the curl and set for 10 seconds.
  • Allow the curl to cool before pulling or styling.
  • Be sure to test a small section of hair underneath your wig to ensure that the curling iron is not too hot! Futura Technology wigs can resist heat up to 400F
  • Blow drying
  • The hair can be blow-dried on low setting, but it is not recommended to do it too often.
  • It is best to let your hair dry naturally after washing.

4. HOW TO MAINTAIN YOUR LACE WIG

You will need:
  • Baby powder
  • Silicon Serum
Steps:
  • Shine: If you find the hair is a bit shiny when you receive it- rinse it in lukewarm water and leave to air dry over night. Alternatively you can use baby powder and tap onto the hair for an instant shine reduction.
  • Moisturising: Use two drops of silicon and stroke into the hair. Do not use oil sheen.
  • Sleeping: Always wear a hair net or head scarf to sleep. This will prevent the hair from tangling and therefore you will need to brush it less.

5. HOW TO WASH YOUR LACE WIG

You will need:
  • Low lather shampoo
Steps:
  • It is advisable to wash your hair with low lather shampoo. Usually any baby shampoo is good. We recommend "JOHNSON'S® Baby NO MORE TEARS Shampoo".
  • Rinse your hair with luke warm water.
  • Apply a small amount of shampoo onto the hair and gently massage the shampoo into the hair by using your fingers in a combing motion (from the top to the bottom.) DO NOT SCRUNCH THE HAIR WITH YOUR FINGERS! YOU DO NOT WANT THE SHAMPOO TO LATHER THE HAIR TOO MUCH!
  • Rinse out the shampoo gently.
  • Apply conditioner (in the same motion as the shampoo) and leave on for 5 minutes.
  • Rinse the conditioner out thoroughly.
  • Do not brush, blow dry or heat style your hair whilst it is wet as this can damage the fibre.
  • How often should I wash my hair?
  • You can start washing the hair after 3 weeks from the first time you wear it, thereafter you can wash every 10 days if needed. If the hair is not dirty, do not wash it unnecessarily.

6. HOW TO REMOVE YOUR LACE WIG

This only applies if you have glued your wig on

You will need: Steps:
  • Pull all the hair up into a ponytail. This will provide better access to the hairline where the remover will be placed
  • Apply Lace Wig Remover around the edges of your lace wig. Let the remover sit for 2-5 minutes.
  • Work with the releaser in your fingers and gently pull the lace wig free.
  • Once you have completely removed the wig shampoo it and be sure to remove any left over glue or tape with a towel. It is best to remove all glue before washing.
  • Let the wig dry naturally. You can then reapply, style and store.

Items you may like

© 2014 Hair Town (Pty) Ltd. All Rights Reserved.